brake boosters are non-manual brakes. They only serve to brake the power to give more braking power with minimal pressure on the brake pedal. A repeater is a device that provides an additional braking force using their hydraulic systems. Often working under pressure, but also work in tandem with the master cylinder that holds the brake fluid liquid by pressing the brake system.
How to install a brake booster?
Jump Starter
First, open the hood and locate theBrake booster. It will be connected to the cylinder on the firewall. Unscrew and remove the nut of the pipe, the brake line to the master cylinder with the key. You can select a tape and a permanent marker on where the brake lines of origin.
Loosen each nut counterclockwise tube and be especially careful that we do not give at the end of the nut while solving. Next, unbolt the two bolts on the brake masterRemove the cylinder on the booster and master cylinder.
Then, seal the five or six nuts holding the brake booster available under the dashboard behind the brake pedal of the vehicle. Then instead of pulling the clip or pin with pliers and tap the pin with the end of the clamp. Drag the Acura brake booster from the firewall and outside the engine compartment. Lower the new booster in the engine room where the old break-booster.
Acura brake booster - a powerful tool to Stop
No comments:
Post a Comment